Conect Vent System; Complete The Installation; Description Of The Hood; Control - ELICA EAS430SS Guía De Instalación, Uso Y Mantenimiento

Connect the vent system
Vented Installations
1 Connect the vent system to the range hood vent opening.
Seal the connection with clamps.
Non-Vented (recirculating) Installations
1 Connect the vent system to the range hood vent opening.
Seal the connection with clamps.
2 Install charcoal filters.
See the "Available accessories" section for Recirculation kit.
Complete installation
1
Replace grease filters. See the "Maintenance" section.
I WARNING
ELECTRICAL SHOCK HAZARD
I WARNING
PLUG INTO A GROUNDED 3 PRONG OUTLET.
DO NOT REMOVE GROUND PRONG.
DO NOT USE AN ADAPTER.
DO NOT USE AN EXTENSION CORD.
FAILURE TO FOLLOW THESE INSTRUCTIONS CAN RESULT
IN DEATH, FIRE, OR ELECTRICAL SHOCK.
2 Plug 3-prong power cord into a grounded 3-prong outlet
located inside the cabinet above the range hood.
3 Check the operation of the range hood fan and light. See
"Description of the hood" section. If range hood does not
operate, check to see whether a circuit breaker has tripped
or a household fuse has blown. Disconnect power and
check wiring connections.
NOTE: To get the most efficient use from your new range
hood, read the "Description of the hood" section.
4 Install the cabinet doors to the cabinet. Use the assembly
instructions that come with the cabinet.

Description of the hood

The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the
hood before cooking and allow it to operate several minutes
after the cooking is complete to clear all smoke and odors
from the kitchen.
The hood controls are located on the center of the front of
the range hood liner.
A. Blower and light controls
B. Grease filter
C. Grease filter handle
D. LED lamps
10
D
C
B
A
Controls
2
1
1.
Light On/Off button
2. Blower On/Off button and speed minimum button
3.
Blower speed medium button
4.
Blower speed maximum button
Operating the light
The Light On/Off button (1) controls both lights. Press once
for On and again for Off.
Operating the blower
The Blower Speed buttons turn the blower on and control the
blower speed and sound level for quiet operation. The speed
can be changed anytime during fan operation by pressing the
desired blower speed button.
Press the Blower Off button a second time to turn off the
blower.

Maintenance

Cleaning
Do not spray cleaners directly to the control while cleaning
the Hood. The cooker hood should be cleaned regularly (at
least with the same frequency with which you carry out main-
tenance of the fat filters) internally and externally. Do not use
abrasive products. Do not use chlorine base cleaners.
DO NOT USE ALCOHOL!
To avoid damage to the exterior surface, do not use steel wool
or soap-filled scouring pads.
Always wipe dry to avoid water marks.
Cleaning Method:
Liquid detergent soap and water, or all-purpose cleanser.
Wipe with damp soft cloth or nonabrasive sponge, then rinse
with clean water and wipe dry.
I WARNING
Failure to carry out the basic cleaning recommendations of
the cooker hood and replacement of the filters may cause fire
risks.
Therefore, we recommend oserving these instructions.
The manufacturer declines all responsibility for any damage to
the motor or any fire damage linked to inappropriate main-
tenance or failure to observe the above safety recommenda-
tions.
Metal grease filter
The filters should be washed frequently. Place metal filters in
dishwasher or hot detergent solution to clean. Let filter dry
throughly before replacing it.
Turn off fan and lights. Allow lamps to cool.
1 Remove each filter by pulling the spring release handle (A)
and then pulling down the filter.
3 4
A