Install In-Blower System - ELICA KIT0179549 Guía De Instalación, Uso Y Mantenimiento

NOTE: The blower motor housing can be mounted using
4 holes from either the inlet side or the outlet side of the
blower.
A
A
A. Mounting holes
1 Using two or more people, move the in-line blower motor
system to the mounting location.
2 Position the in-line blower motor housing in its mounting
location and mark the 4 mounting hole locations.
3 Drill 4 mounting pilot holes using a ³⁄₁₆" (0.5 cm) drill bit.
4 Attach the in-line blower motor housing to the mounting
location with mounting 4 - 6.3 x 60 mm screws and 4 - 4
x 1.8 mm washers. Parts are included with the range hood
motor kit.
5 If removed, reinstall the blower motor assembly and secure
it with the screws previously removed.
6 If removed, reattach the motor electrical plug to the
connector on the blower motor assembly.
Complete Preparation
1 Determine and make all necessary cuts for the vent system.
IMPORTANT: When cutting or drilling into the ceiling or
wall, do not damage electrical wiring or other hidden
utilities.
2 Determine the location where the ¹⁄₂" (1.3 cm) wiring
conduit will be routed through the ceiling or wall between
the in-line blower and the range hood.
12

Install In-Blower system

A
A
A
A
3 Drill a 1¹⁄₄" (3.2 cm) hole at this location.
4 Locate the electrical terminal boxes in the in-line blower
housing and range hood. Remove the terminal box covers
and set the covers and screws aside.
B
A
5 Remove the electrical knockout from the in-line blower
housing and range hood (see the range hood installation
instructions) to prepare for the installation of the UL listed
or CSA approved ¹⁄₂" (1.3 cm) wiring conduit and conduit
connector.
6 With the range hood mounted (see the range hood
installation instructions), run the ¹⁄₂" (1.3 cm) wiring conduit
between the in-line blower motor housing and the range
hood. Pull enough ¹⁄₂" wiring conduit to allow for easy
connection to the terminal boxes in the in-line blower
housing and range hood.
E
D
C
B
A. In-Line Blower Kit
B. Range Hood Terminal Box
C. Power Supply wiring Conduit
A. Terminal Box Cover
B. Knockout
F
A
D. In-Line Blower Wiring Conduit (not
included)
E. In-Line Blower Terminal Box
F. In-Line Motor Electrical Plug Cable