GE Profile DPGT750 Manual De Instrucciones página 19

UNPACKING YOUR DRYER
Tilt the dryer sideways and remove the foam
shipping pads by pulling at the sides and
breaking them away from the dryer legs.
Be sure to remove all of the foam pieces
around the legs.
Remove the bag containing the drying rack,
literature and serial cable.
LOCATION OF YOUR DRYER
IMPORTANT:
Gas dryers are not approved
for mobile home installation.
MINIMUM CLEARANCE OTHER
THAN ALCOVE OR CLOSET
INSTALLATION
Minimum clearance to combustible surfaces
and for air openings are:
• 0 inch clearance both sides
• 1 inch front
• 3 inches rear
Consideration must be given to provide
adequate clearance for proper operation and
service.
Installation Instructions
19
SWITCH WASHER AND DRYER
BACKSPLASHES (optional)
If necessary, switch the backsplashes for the
washer and dryer before making exhaust or
utility connections (see "Switching the
Washer and Dryer Backsplashes").
DRYER DIMENSIONS
Front View
Side View
35 1 ⁄ "
2
(90.2 cm)
51"
(129.5 cm)
43 ⁄
1
8
(109.5 cm)
27"
(68.6 cm)
37 1 ⁄
(94.6 cm)
29"
(73.7 cm)
"
"
4