GE Profile DPGT750 Manual De Instrucciones página 38

DISCONNECT WASHER
3
CONTROL BOARD
Disconnect the ribbon at the right of the
control board by pulling the connector at the
end of the ribbon off the metal pins on the
control board.
NOTE: Do not disconnect any other wires
from the control board.
Rear of Washer
REMOVE CONTROL BOARD
4
FROM WASHER BACKSPLASH
Remove the four screws holding the control
board to the backsplash. Remove the control
board and set it aside.
Screws
Installation Instructions
Ribbon
38
REMOVE DRYER BACKSPLASH
5
Place a towel over the top surface of the dryer
to prevent scratches to the surface.
Remove the four screws from the rear of the
dryer backsplash. Rotate backsplash forward
and lift off.
Screws
Rear of Dryer
DISCONNECT DRYER CONTROL
6
BOARD
Disconnect the ribbon at the right of the
control board by pulling the connector at the
end of the ribbon off the metal pins on the
control board.
NOTE: Do not disconnect any other wires
from the control board.
Rear of Dryer