Adjusting The Harness; Using The Blower - Shindaiwa EB630 Manual Del Operador

Throttle Control (EB630RT)
The EB630RT is equiped with a multi-
function throttle control. The "Cruise"
function allows the operator to use a thumb
controlled lever for constant speed use
without using the throttle trigger. This is
useful for limiting the fatigue caused from
holding the throttle for extended periods of
time.
On the opposite side, a two position
"limiter" control allows full engine speed
when set for "Turbo" or limits the throttle
to a pre-set engine speed when set to low
noise (dB) setting.
CRUISE FUNCTION
Using the right thumb, push the throttle
lock lever down until the desired RPM
setting is reached. See Figure 18.
Thumb
Control
Lever
63020
Figure 18
To bring RPM down to idle, push lever
back up into original position.

Adjusting The Harness

The Shindaiwa EB630 Blower features an
advanced harness system that helps
ensure maximum operator comfort and
ease of operation. See Figure 17.
■ The shoulder harness is filled with soft
padding for reduced operator fatigue.
■ The simplified adjustment system
makes it easy to match the harness to
every body size and type.

Using The Blower

OPERATING TIPS
In the hands of an experienced operator,
the EB630 can efficiently move a wide
variety of debris ranging from grass
clippings to gravel. As a general rule,
operate your blower at the lowest throttle
setting required to get the job done:
■ Use low throttle settings when clearing
lightweight materials from around
lawns or shrubbery.
■ Use medium to higher throttle settings
to move grass or leaves from parking
lots or walkways.
■ Use full throttle when moving heavy
loads such as dirt or snow.
10
THROTTLE LIMITER
The EB630RT has a throttle limiter
function that allows the operator to pre-set
the maximum engine speed. This is useful
for reducing the noise emitted by the
blower in noise sensitive areas.
Setting throttle limiter:
For reduced noise setting, move the
throttle limiter located on the right side of
the throttle control to the dB setting.
See Figure 19.
Throttle Limiter Adjustment
Turbo Setting
dB Setting
Throttle Limiter
Figure 19
Comfortable
Back Pad
Quick-
disconnect
Spring Hook
Quick-adjust
Buckle
Figure 17
IMPORTANT!
Blower noise increases at higher throttle
settings! Always use the lowest throttle
setting required to get the job done!
Adjusting throttle limiter:
1. Remove the plug located at the top of
the throttle assembly. See Figure 20.
2. Move the throttle limiter lever to the
"dB" setting. See Figure 20.
3. With the engine running and while
depressing the throttle trigger, use a
small Phillips screw driver to turn the
adjustment screw clockwise to de-
crease RPM and counterclockwise to
increase until desired limited RPM is
achieved.
4. Reinstall limiter adjustment plug.
Remove limiter
adjustment plug
Lever
Figure 20
With the throttle limiter adjusted to 4,000
RPM, the EB630RT will have a sound level of
65 dB(A) measured at 50 feet.
To tighten straps...
Easy-adjusting
Buckles
To loosen straps...
Pull the
quick-adjust
buckles up...
...and pull the
straps down.
Pull on the loops to
quickly tighten the
harness straps
63022
63021
NOTE:
Quick-adjust
Buckle
Pull strap
loops
down