Introduction
The following pictogrammes / symbols are used in these operating instructions:
Read the operating instructions!
Always heed warning labels and
safety instructions!
Caution - Danger of electric shock! Hazardous
voltage – danger to life!
Explosive material!
Risk of fire!
Battery charger T4X
for rechargeable batteries / batteries from
1.2 Ah to 120 Ah
Introduction
Q
For your safety
Q
Please carefully read these operating in-
structions and fold out the page with the
illustrations.Observe this information
exactly when putting the appliance into operation.
If you have any further
questions regarding use, please contact the service
department responsible for your country. Keep these
operating instructions in a safe place and hand them
over to anyone to whom you pass on the appliance.
Proper Use
Q
The TRONIC T4X is a primarily mains-connected
(working with measuring and control functions)
charging station with pulse trickle charge function,
suitable for charging and trickle charging 12 V lead
accumulators (batteries) with electrolyte solution or
gel. The charger has a circuit-breaker as protection
against sparking and overheating.
22 GB/MT
W
Watts (effective power)
V ~
Volt (AC)
Proper procedure and handling.
Keep children and other unauthorised personnel
at a safe distance when using electrical tools.
Dispose packaging and appliance in an
environmentally-friendly way!
Operate the charging appliance in a warmed and
well ventilated room. Any incorrect or improper use
leads to loss of the warranty. The manufacturer
takes no responsibility for damage(s) arising out of
usage that is contrary to the instructions laid down.
The appliance is not meant for commercial use.
Delivery Contents
Q
Check the appliance and all accessories for dam-
age immediately after unpacking. Do not put a de-
fective appliance or parts into operation. Please
contact the resonsible service department for
a replacement.
1 Charger TRONIC T4X
2 Quick / contact clamps (1 red, 1 black)
1 Operating manual
Guarantee documents
Component description
Q
STANDBY LED display :"STANDBY" (standby)
1
LED display „Mode 1"
2
LED display „Mode 2"
3
LED display „Mode 3"
4
LED display „incorrect polarity/fault"
5
LED display „fully charged"
6
LED display „Charging process active"
7