Selecting And Starting Programmes; 10.4 Programme End; 10.5 After A Power Failure - Amann Girrbach ceramill therm s Manual Del Usuario

10.3 Selecting and starting programmes

After switching on the furnace, the Programme
Manager is automatically displayed on the touch-
screen.
▷ Select the desired programme.
The firing procedure of the selected programme
is displayed.
▷ In the programme indication, tap on
The programme is automatically run.
NOTE:
During the run of a programme, the lift automat-
ically moves up and down.
▷ Make sure that no objects obstruct the lift's
motion.
▷ Do not attempt to manually stop or accelerate
the lift.
During the programme run, the pro-
gramme can be cancelled by tapping
Stop
on .

10.4 Programme end

For chamber temperatures T > 999 °C, the
firing chamber generally remains shut. It
cannot be opened until the chamber tem-
perature is below 999 °C.
_ After a regular programme ends, an acoustic
Start
.
signal sounds.
_ The lift moves down.
_ The firing number is automatically increased by
one.
During the programme run, the programme can
be cancelled by tapping on
commands are terminated and the heating is
switched off. The furnace cools down. The firing
run is not counted, meaning, the firing number
does not increase.

10.5 After a power failure

After a power failure, the control system remem-
bers the condition of the furnace at the time of
interruption for up to two hours.
When the power supply is reactivated within these
two hours, the furnace will restore the condition
at the time of the interruption. If the temperature
drop in the firing chamber does not exceed
150 °C, the firing programme being executed with
continue.
Otherwise, the furnace will prompt the inquiry, if
the programme is to be continued.
O P E R A T I O N
Stop . In this case, all
E N
79