Sirius SCISIU24TC Istrucciones De Uso página 18

Lift the upper tube (Fig. 7.5) up to the ceiling
and insert the two self-tapping screws (Fig.
7.5-D).
*Filtering model
Place the upper plate (Fig.5.1) on the cei-
ling. Drill 4 holes, 8 mm each, just next to
the slots. Insert the plastic dowels into the
holes (Fig.5.1-A). Fix the baffle (Fig. 5.2) to
the upper bracket (Fig.5.3) with the four self-
tapping screws provided (Fig. 5.3 A). Screw
up the plate together with the baffle (Fig.5.1
B). Then fasten the lower structure (Fig. 7.2)
on the hood by making its holes and the me-
tric-thread screws welded on the fan support
coincide (Fig. 7.1). Insert the washers and
nuts provided (Fig. 7.2-A) and screw with an
appropriate tool. Connect the drainpipe to
the power unit nozzle and fix securely with
a hose clamp. Insert the upper structure (Fig.
7.3) into the lowest one and adjust its hei-
ght as required by matching it with the coo-
king top's minimum height. Tighten the two
structures securely with the screws provided
(Fig. 7.3-B). Insert the two extension tubes
(Fig. 7.4 & Fig. 7.5) from above the two struc-
tures by making them come down to the ap-
propriate hood seat.
Lift the hood together with the structure and
the extension tubes to make the four sprin-
gs (Fig. 7.6-E) hook to the slots (Fig. 7.3-C).
Then tighten the two elements securely (Fig.
6.1 & Fig. 6.2) with the safety screws (Fig.
6.2-A) and connect the hood tube to the baf-
fle's lower hole.
Make the electrical connections. (For versions
with display only) Lift the lower pipe until the
cable strap coming out of the sucking unit is
uncovered and connect it to the display cable
strap. Put down the lower pipe while paying
attention it is being properly introduced into
the hood. Lift the upper tube (Fig. 7.5) up to
the ceiling and insert the two self-tapping
screws (Fig. 7.5-D).
Warning!
Before connecting the flexible exhausting
pipe to the motor, make sure the stop valve,
which is on the air outlet of the motor, can
swing.
EXTERNAL MOTOR VERSION:
Connect the the external motor's cable to the
terminal board found in side the plastic box of
the wiring . Make sure to respect the colors
of cables when perfor ming the electrical con-
nection (Fig. 18).
18