Back Panel Of The Powerline Av 4-Port Network Adapter (Model Number: Pls300); Placement Options - Cisco Linksys Powerline AV PLE300 Guia Del Usuario

Chapter 2
HomePlug Simple Connect Button
HomePlug Simple Connect button to configure
advanced security for your powerline network.
For instructions, refer to Chapter 3: Advanced
Security, page 6.
Power
(Blue) The power LED lights up when
the Adapter is powered on.
Ethernet
(Blue) These
correspond with the numbered Ethernet ports
on the back panel. A LED lights up when its
corresponding port is connected to a network
device. It flashes to indicate network activity
over that port.
Powerline
(Blue) The Powerline LED lights
up when the Adapter is connected to the
powerline network through the Power port. The
LED flashes to indicate network activity over
that port.
Back Panel of the Powerline AV 4-Port
Network Adapter (model number: PLS300)
Ethernet 1-4 These Ethernet ports (1, 2, 3,
4) connect to computers or other network
devices.
Reset
To restore the factory default settings
(including the advanced security setting,
Network Password), press and hold the Reset
button for three seconds.
Power
The Power port connects to the
powerline end of the power cord.

Placement Options

There are three ways to place the Adapter. The first way
is horizontal placement on a surface. The second way
is vertical placement on a stand. The third way is wall-
mounting.
Horizontal Placement
Place the Adapter on a level surface near an electrical
outlet.
Powerline AV Network Adapter
Use the
numbered LEDs
Vertical Placement
The stand fits only on the side panel adjacent to the Power
port.
1. Insert the stand into the side panel until it snaps into
place.
NOTE:
When the Adapter is on the stand, the
Power port is closest to the stand.
Insert Stand into Side Panel
2. Place the Adapter on a level surface near an electrical
outlet.
Product Overview
Fourth Slot of
Side Panel
4