Reassembly; Important - Titan FLEXSPRAY Manual De Uso

Reassembly

To reassemble:
1. Install the nozzle seal with the groove (a)
(slot) facing toward the nozzle (away from
the front end assembly).
Insert the nozzle. Make sure to align the
groove (b) and notch (c) and align the
nozzle opening with the needle.
2. Put the air cap (d) on the nozzle (e) and
secure with the connecting nut (f).
3. Snap the adjustment ring (g) into the
connecting nut, enabling the adjustment
lever (h) on the peg (i) to be positioned in
the air cap.
note: Make sure that the two recesses on the
adjustment ring are engaged in the air cap tabs.
4. Place the container seal on the suction
tube and slide it over the collar (j), while
turning the container seal slightly.
5. Insert the suction tube with the container
seal into the front end assembly.
6. Replace container.
Transportation / storage
1. Detach the strap from the sprayer and
secure it to the carry case (it can also be
stored inside the carry case).
2. Place the unit and accessories into the
carry case as shown below and secure with
the elastic straps.
3. Coil the power cord and use the provided
velcro strap to secure.
note: Press the right and left inside of the case
lid outwards in order to open up the transport
case completely.
English
Start

IMPORTANT:

Follow the steps described below for
reassembly. Improper reassembly can result in
damage to the spray gun assembly.
1
a
b c
3
h
g
5
12
2
f
4
i
j
6
e
d