WEG KVDC-CFW11-2 Guia De Instalacion página 10

External Power Supply for Control in 24 Vdc - KVDC-CFW11-2
Step
8
Loosen the screw and the flat cable of the safety stop board as indicated.
9
Only frame size D
Loosen the two screws in the upper part
of the top front cover, then remove the two
screws in the lower part of the same cover.
Remove the upper front cover.
10
Loosen the four screws at the ends and remove the central cover.
10 | CFW-11/CFW70X
Actions/Instructions
Only frame size H
Only frame sizes F and G
Loosen the two screws in the upper part
of the top front cover, then remove the two
screws in the lower part of the same cover.
Pass the control rack through the opening on
the top front cover and remove the cover.
Only frame size H