WEG KVDC-CFW11-2 Guia De Instalacion página 18

External Power Supply for Control in 24 Vdc - KVDC-CFW11-2
Step
29
Fit the ribbon-cable, the plastic cover on the
connector and ground cable to the XC98
connector of the vertical board of the control
30
Position the ground flexible braid in the lower right fixation point of the top front cover.
31
Tighten the four screws of the top front cover.
18 | CFW-11/CFW70X
Actions/Instructions
Only frame sizes D and H
board.
Only frame sizes F and G
Frame size D
Fit the ground flexible braid on the lower
point on the screening plate of the control
board.
Frame sizes F, G and H
Tighten the four screws of the top front cover
(the ground flexible braid must be fastened
together on the right side as shown in the
previous step).