Label; Check After Installation - WEG KVDC-CFW11-2 Guia De Instalacion

External Power Supply for Control in 24 Vdc - KVDC-CFW11-2

4 LABEL

Put the two labels (k) supplied with the product after installing the kit on the inverter.
Those labels indicate that the inverter features the KVDC kit, which was not supplied from factory.
The labels must be put next to the product identification labels: one close to the big label, located
on the side of the inverter, and the other close to the label located under the HMI.
Side of the inverter Under the HMI
Figure 3: Suggested location to put up the labels supplied with the KVDC kit

5 CHECK AFTER INSTALLATION

After the installation of the kit in the inverter is concluded, power up the inverter and see if the
content on the parameter P0029 (Configuration of Power Hardware), on the bit 10 = 0.
For a description of the inverter operation with the KVDC kit refer to the user's manual in the
chapter for optional items.
20 | CFW-11/CFW70X