WEG KVDC-CFW11-2 Guia De Instalacion página 15

External Power Supply for Control in 24 Vdc - KVDC-CFW11-2
Step Actions/Instructions
21
Frame size D Frame size F Frame size G and H
- Connect the supplied 160-mm ribbon- Ribbon-cable 160 mm Ribbon-cable 533 mm (j)
cable (h) to the XC60 connector (CC11x) and
Fit the ribbon-cable according to length and
snap the plastic cover on.
indication above, and then fit the plastic cover
- Fasten the clamp, fixing the ribbon-cables
(f) on the connector, on the VDCx board.
as indicated.
Make sure the position of the ribbon cable is
Make sure the position of the ribbon cable is
as shown in the figure.
as shown in the figure.
22
Frame sizes F and G Frame sizes D and H
Fasten the clamp (E), fixing the ribbon-cables as indicated.
CFW-11/CFW70X | 15