WEG KVDC-CFW11-2 Guia De Instalacion página 14

External Power Supply for Control in 24 Vdc - KVDC-CFW11-2
Step
19
Frame size D and H
Fit the VDCx board (a) over the plastic spacer
and tighten the two screws (g) on the VDCx
board on the metal spacers.
Note: the inverters of frame size H have 2
plastic spacers.
20
Frame size D and H
Fit the ribbon-cable to the XC60A connector (P11x/IPHx/DFO2x) of the VDCx board and fit
14 | CFW-11/CFW70X
Actions/Instructions
Fit the VDCx board (a) over the plastic spacer
and tighten the three screws (g) on the VDCx
Note: if a metal spacer is not assembled,
the plastic cover (f) on this connector.
Frame sizes F and G
board on the metal spacers.
one screw is not used.
Frame sizes F and G