WEG KVDC-CFW11-2 Guia De Instalacion página 12

External Power Supply for Control in 24 Vdc - KVDC-CFW11-2
Step
13
Fit the plastic spacer (c) as indicated.
Note: the metal spacers are assembled at
14
Screw the metal spacers (b) where the grounding screws were, and fit in the plastic spacers
15
12 | CFW-11/CFW70X
Actions/Instructions
Frame size D
the factory.
Only frame size H
(c) as indicated.
Frame sizes F, G and H
Remove the ferrite by loosening the two screws as indicated.
Frame sizes F and G
Screw the metal spacers (b) where previously
the ground screws where located and fit the
plastic spacer (c) as indicated.
Note: some inverters do not feature the lower
left ground point; in this case, assemble only
two metal spacers.