WEG KVDC-CFW11-2 Guia De Instalacion página 13

Step
16
Remove the 160-mm ribbon-cable connected to connector XC60 of the power interface
board (DFO2x) and connect the 260-mm ribbon-cable (i) to this connector XC60. Fit the
Remove the 380-mm ribbon-cable connected to connector XC60 of the power interface
board (IPHx) and connect the 160-mm ribbon-cable (i) to this connector XC60. Fit the ferrites
17
18
Frame sizes D and H
External Power Supply for Control in 24 Vdc - KVDC-CFW11-2
Actions/Instructions
Frame sizes F, G and H
Frame size F and G:
ferrites on the ribbon-cable and tighten the two screws.
Frame size H:
on the ribbon-cable and tighten the two screws.
Only frame sizes F and G
Fold the ribbon-cable as indicated.
Position and fit the insulation (d) on the spacers.
Frame sizes F and G
CFW-11/CFW70X | 13