G-U BKS B-1893 Serie Manual De Instalación página 64

Installation instructions
B-1893x | B-1993x
Motor-driven shoot-bolt lock for narrow stile systems
64
Problem
"Locked" signal does not
appear
Signal "Unlocked" position
does not appear
Latch monitoring without
function
Deadbolt monitoring not
functional
(only with B-1893x)
Daytime release cannot be
adjusted
Programming mode cannot be
initiated
EN
Cause
y y "Locked by motor" relay
contact is not assigned.
y y Lock cannot move to initial
position
y y
"Unlocked by motor" relay
contact is not assigned.
y y Lock cannot move to final
position
y y Incorrect cable assignment
y y Incorrect cable assignment
y y Link not severed
y y The signal at the control
input drops out
y y Service plug not inserted
y y Service plug not removed
between 2 programming
procedures
Help
y y Check wiring
Signal input (BK, GY, BNGN)
Signal output (terminal
41 and 51) (see point 1.1)
y y Foreign object in the lock
y y
Check wiring
Signal input (BK, GY, RDBU,
WHGN)
Signal output (terminal
42 and 52) (see point 2.4)
y y Foreign object in the lock
y y Check wiring
Signal input (RD)
Signal output (terminal
44 and 54) (see point 2.4)
y y Check wiring
Signal input (VT)
Signal output (terminal
43 and 53) (see point 2.4)
y y Sever link (see point 4.4)
y y Make sure that the control-
ler is receiving a continuous
signal
y y Insert the service plug into
the controller (see point 6)
y y The service plug must be
removed in order to exit
programming mode. You
can only start another
programming operation
once you have done this
(see point 6)
10.2017 | 20734ES | Designed in Germany