Fault Indications; Causes And Rectification Of Faults - CASO DESIGN MCDG 25 Master Manual De Instrucciones

15.2 Fault indications

In the event of a fault, an error code will appear in the display; it describes the cause of the
fault.
Error code Description
E01 Excessive temperature within cooking chamber
The overheating cut-out terminated the current program at a cooking
chamber temperature of 250 °C.
Press the Stop button to acknowledge this fault.
The device can be re-activated after the cool down phase.
Low temperature protection
E02
When the system enters into super low temperature protection status, the digital
display shows "E02" and continues to beep till the system comes back to normal
condition and then press "Stop".
E03 Sensor fault
The device has detected an error on a sensor and has terminated the
current programme.
Press the Stop button to acknowledge this fault.
Please note
► If error messages continue to appear after an extended waiting period and restarting
the device, then the device will need to be sent to Customer Service to be inspected.

15.3 Causes and rectification of faults

The following table assists in localizing and rectifying minor faults.
Error
The selected program will
not start.
The turntable turns jerkily.
Food is not sufficiently
defrosted, warmed up or
cooked after preset time
has elapsed.
caso MCDG 25 Master (black)
Possible cause
Device door is not closed
Power plug is not
plugged in
Fuse is not activated
Dirt between the turntable
and the base of cooking
camber
Dirt on rolling ring
Cooking vessel too large
Incorrectly selected time
or power level
Action
Close device door
Plug in mains plug!
Activate fuse
Remove dirt
Use different cooking vessel
Re-set time and power level
Repeat process
64