Troubleshooting; Safety Notices; Fault Indications - CASO DESIGN MCG30 Chef Manual Del Usuario

Please note
► Leave the oven door open to prevent the device from being re-started accidentally.
 Exterior housing
 Clean the exterior surfaces of the device with a damp cloth.
 Rotating plate and rolling ring
 The glass turntable must be removed and cleaned occasionally. Wash the plate in a
warm soapy solution or in the dishwasher.
 The rolling ring should be cleaned regularly to prevent excessive noise development or
a rotational malfunctions.
The rolling ring can be washed in a mild soapy solution or in the dishwasher. Please
remember to put the rolling ring back again properly after cleaning it.
 Wipe the bottom of the oven with a mild cleaning agent. If the floor of the oven is
excessively dirty, you can use a mild cleaning agent.

15 Troubleshooting

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:

15.1 Safety notices

Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.

15.2 Fault indications

In the event of a fault, an error code will appear in the display; it describes the cause of the
fault.
Error code Description
E-01 Excessive temperature within cooking chamber: The overheating cut-
out terminated the current program at a cooking chamber temperature of
300°C. Press the Stop button to acknowledge this fault.
The device can be re-activated after the cool down phase.
E-03 Sensor fault: The device has detected an error on a sensor and has
terminated the current programme.
Press the Stop button to acknowledge this fault.
caso MCG30 Chef (pure white, black) 69