Fault Indications; Causes And Rectification Of Faults - CASO DESIGN MCG 25 Chef Manual Del Usaurio

13.2 Fault indications

In the event of a fault, an error code will appear in the display; it describes the cause of the
fault.
Error code
E01 Excessive temperature within cooking chamber
The overheating cut-out terminated the current program at a cooking
chamber temperature of 300°C. Press the Stop button to acknowledge this
fault. The device can be re-activated after the cool down phase.
E03 Sensor fault
The device has detected an error on a sensor and has terminated the
current programme. Press the Stop button to acknowledge this fault.
► If error messages continue to appear after an extended waiting period and restarting the
device, then the device will need to be sent to Customer Service to be inspected.

13.3 Causes and rectification of faults

The following table assists in localizing and rectifying minor faults.
Error
The selected program will
not start.
The turntable turns
jerkily.
Food is not sufficiently
defrosted, warmed up or
cooked after preset time
has elapsed.
The device functions but
the cooking chamber
lighting does not work.
Abnormal noises can be
heard during operation of
microwave.
caso MCG 25 Chef (pure white, black)
Please note
Possible cause
Device door is not closed
Power plug is not plugged in
Fuse is not activated
Dirt between the turntable and
the base of cooking camber
Dirt on rolling ring
Cooking vessel too large
Incorrectly selected time or
power level
Defective cooking chamber
light.
Food is covered with aluminium
foil
The cookware contains metal
and sparks are being created
within the cooking chamber
Description
Close device door
Plug in mains plug!
Activate fuse
Remove dirt
Use different cooking vessel
Re-set time and power level
Repeat process
Have Service dept repair
cooking chamber light.
Remove aluminium foil
Observe information on
cookware!
Action
70