Troubleshooting; Safety Notices; Fault Indications - CASO DESIGN MCG20 Chef Manual Del Usuario

 Front of device and operating panel
 Clean the front of the device and the operating panel with a soft, slightly damp cloth.
 Please bear in mind that the operating panel does not get wet. Use a soft, damp cloth
for cleaning.
► Leave the oven door open to prevent the device from being re-started accidentally.
 Exterior housing
 Clean the exterior surfaces of the device with a damp cloth.
 Rotating plate and turnable cross
 The glass turntable must be removed and cleaned occasionally. Wash the plate in a
warm soapy solution or in the dishwasher.
 The turnable cross should be cleaned regularly to prevent excessive noise development
or rotational malfunctions.
The turnable cross can be washed in a mild soapy solution or in the dishwasher.
Please remember to put the turnable cross back again properly after cleaning it.
 Wipe the bottom of the oven with a mild cleaning agent. If the floor of the oven is
excessively dirty, you can use a mild cleaning agent.

16 Troubleshooting

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:

16.1 Safety notices

Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.

16.2 Fault indications

In the event of a fault, an error code will appear in the display; it describes the cause of the
fault.
Error code Description
E01 Excessive temperature within cooking chamber
The overheating cut-out terminated the current program at a cooking
chamber temperature of 250°C.
Press the Stop button to acknowledge this fault.
The device can be re-activated after the cool down phase.
Please note
75