Festo HSP Serie Instrucciones De Utilizacion página 39

HSP−...
Fitting: Mechanical components
The HSP−... is supplied ready for fitting.
If necessary, remove the protective cover before fitting.
S
Fit first the add−on components and, in the case of the HSP−...−AS, the external
S
drive or after fastening make sure that there is sufficient free space for fitting
the components.
Make sure that the fastening surface can support the weight of the HSP−... .
S
Fit the HSP−... only onto a flat fixed surface.
S
Select one of the following fastening methods:
Direct fastening via 4 through holes in the sub−base
[mm]
H1
H2
@ D1
L1
Fastening via the side plates
(user−specific hole pattern).
Fastening on the rear of the sub−base with
sliding blocks type HMBN−5−M5
(Fig. 8) or
fastening kit type HMBK−ND and
connecting bracket type HMBV−ND
(example: Fig. 9).
Festo HSP−... 0308 NH English
HSP−12 HSP−16
40 20
40±0.2 100±0.2
6.3 6.3
200±0.6 280±0.6
HSP−24
40
100±0.2
6.3
370±0.6
Fig. 7
Fig. 8
L1
39