Master Forge 3218LTN Manual De Instrucciones página 18

ASSEMBLY INSTRUCTIONS
19. Take the pressure regulator out from under
the burner box (A). Then lift the burner box (A)
onto the cabinet, making sure that the gas
pressure regulator is in the cabinet, then position
burner box on the cabinet by aligning the four
tabs on top of the cabinet with the holes in the
burner box. Fasten the burner box to the
cabinet with 4 screws (BB). (Fig. 19)
Hardware Used
1/4-20 x 5/8 in.
BB
Screw
20. Route the light wire from the burner box (A)
through the bottom of the burner box into the
cabinet. Then pull the wire through the
opening in the left rear panel (I).
(Fig. 20)
19
Tab
BB
X 4
20
18
light wire
I
Lowes.com/masterforge
A
Pressure
regulator