Master Forge 3218LTN Manual De Instrucciones página 41

CARE AND MAINTENANCE
Bulb specification
Bulb Type: Halogen
Wattage: 10 watts per bulb
Voltage: 12 volts
Please contact customer service at 1-800-963-0211 for assistance on bulb replacement
information.
Checking the Flame
Refer to Fig. 50 below (side view of grill). Check the flame after the grill is lit. Make sure you
have a stable mostly blue flame.
Air Shutter Adjustment
The main burner shutters are adjusted at the factory for your convenience. The settings are:
(1) Full open for LP gas.
(2) Half open for NG gas.
If you desire to fine tune your shutter adjustment (or if your flame is more yellow rather than
blue), please follow this procedure.
WARNING: Do not touch burner after adjustments. The burner is hot.
a. Loosen the air shutter. The shutters are located on the end of the gas burners
underneath the control box. See Fig. 51
b. Loosen the air shutter screw.
c. Light the burner to be adjusted.
d. With a protected gloved hand, fine tune the air shutter until a stable, mostly
blue flame is observed through the flame observation hole and slots on each
side of the burner box. Acceptable flames are shown in Fig. 52
e. Tighten the air shutter locking screw enough to hole the shutter in place.
Repeat procedure on other burners.
f.
Flame Observation Hole and Slots
41
Fig. 50
Lowes.com/masterforge