Installation
Installing the GPS aerial
WARNING
Do not install the GPS aerial over any sen-
sors or vents on the dashboard of the vehicle,
as doing so may interfere with the proper
functioning of such sensors or vents and may
compromise the ability of the metal sheet
under the GPS aerial to properly and se-
curely affix to the dashboard.
CAUTION
Do not cut the GPS aerial lead to shorten it
or use an extension to make it longer. Alter-
ing the aerial cable could result in a short cir-
cuit or malfunction and permanent damage
to this product.
Installation notes
! The aerial should be installed on a level sur-
face where radio waves will be blocked as
little as possible. Radio waves cannot be re-
ceived by the aerial if reception from the sa-
tellite is blocked.
1
1 Dashboard
2 Rear shelf
! When installing the GPS aerial inside the
vehicle, be sure to use the metal sheet pro-
vided with your system. If this is not used,
the reception sensitivity will be poor.
! Do not cut the accessory metal sheet. This
would reduce the sensitivity of the GPS aer-
ial.
! The metal sheet contains a strong adhesive
! Take care not to pull the aerial lead when
! Do not paint the GPS aerial, as this may af-
! Some models use window glass that does
For details on the installation method for each
vehicle type, refer to the separate installation
manual and install this product properly.
2
which may leave a mark on the surface if it
is removed.
removing the GPS aerial. The lead may be-
come detached.
fect its performance.
not allow signals from GPS satellites to
pass through. On such models, install the
GPS aerial on the outside of the vehicle.
Section
03
21
Engb