Troubleshooting; Safety Notices; Fault Indications - Caso MCG 25 Chef Manual De Instrucciones


Front of device and operating panel
•
Clean the front of the device and the operating panel with a soft, slightly damp cloth.
•
Please bear in mind that the operating panel does not get wet. Use a soft, damp cloth
for cleaning.
► Leave the oven door open to prevent the device from being re-started accidentally.

Exterior housing
•
Clean the exterior surfaces of the device with a damp cloth.

Rotating plate, baking sheet and rolling ring
•
The glass turntable and baking sheet must be removed and cleaned occasionally. Wash
the plate in a warm soapy solution or in the dishwasher.
•
The rolling ring should be cleaned regularly to prevent excessive noise development or
a rotational malfunctions.
The rolling ring can be washed in a mild soapy solution or in the dishwasher. Please
remember to put the rolling ring back again properly after cleaning it.
•
Wipe the bottom of the oven with a mild cleaning agent. If the floor of the oven is
excessively dirty, you can use a mild cleaning agent.

13 Troubleshooting

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:

13.1 Safety notices

► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.

13.2 Fault indications

In the event of a fault, an error code will appear in the display; it describes the
cause of the fault.
Error code
E01 Excessive temperature within cooking chamber
The overheating cut-out terminated the current program at a cooking
chamber temperature of 300°C. Press the Stop button to acknowledge this
fault. The device can be re-activated after the cool down phase.
caso MCG 25 Chef (pure white, black)
Please note
Attention
Description
69