Troubleshooting; Safety Notices; Causes And Rectification Of Faults - Caso MIG 25 Ceramic Manual Del Usuario


Metal rack and base plate
The metal rack occasionally needs to be cleaned. Wash the metal rack in a warm soap
solution. Wipe the bottom of the oven with a mild cleaning agent. If the floor of the oven is
excessively dirty, you can use a mild cleaning agent.

15 Troubleshooting

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:

15.1 Safety notices

Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out any
repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and damages
to the device.

15.2 Causes and rectification of faults

The following table assists in localizing and rectifying minor faults.
Error
The selected program will not
start.
Food is not sufficiently
defrosted, warmed up or
cooked after preset time has
elapsed.
The device functions but the
cooking chamber lighting
does not work.
Abnormal noises can be
heard during operation of
microwave.
The time in the display field is
not correct.
► If you are unable to solve the problem with the steps shown above, please contact
Customer Service.
Possible cause
Device door is not closed
Power plug is not plugged in
Fuse is not activated
Incorrectly selected time or
power level
Defective cooking chamber
light.
Food is covered with aluminium
foil
The cookware contains metal
and sparks are being created
within the cooking chamber
Power failure
Please note
Action
Close device door
Plug in mains plug!
Activate fuse
Re-set time and power level
Repeat process
Have Service dept repair
cooking chamber light.
Remove aluminium foil
Observe information on
cookware!
Re-set time
65