Troubleshooting; Safety Notices; Causes And Rectification Of Faults - Caso TMG25 MenuTouch Instrucciones De Funcionamiento Originales


Rotating plate, rolling ring and metal rack
•
The glass turntable and the metal rack must be removed and cleaned occasionally.
Wash the plate and the rack in a warm soapy solution or in the dishwasher.
•
The rolling ring should be cleaned regularly to prevent excessive noise development or
a rotational malfunctions.
•
The rolling ring can be washed in a mild soapy solution or in the dishwasher. Please
remember to put the rolling ring back again properly after cleaning it.
•
Wipe the bottom of the oven with a mild cleaning agent. If the floor of the oven is
excessively dirty, you can use a mild cleaning agent.

12 Troubleshooting

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:

12.1 Safety notices

► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.

12.2 Causes and rectification of faults

The following table assists in localizing and rectifying minor faults.
Error
The selected program will
not start.
The turntable turns jerkily.
Food is not sufficiently
defrosted, warmed up or
cooked after preset time has
elapsed.
caso TMG25 MenuTouch
Attention
Possible cause
Device door is not closed
Power plug is not plugged in
Fuse is not activated
Dirt between the turntable
and the base of cooking
camber
Dirt on rolling ring
Cooking vessel too large
Incorrectly selected time or
power level
Action
Close device door
Plug in mains plug!
Activate fuse
Remove dirt
Use different cooking vessel
Re-set time and power level
Repeat process
66