Tabla de contenido
Publicidad
110
'98 12 21
10:35
3
DISPLAYING PICTURES ON
E
THE LCD MONITOR
TURNING ON THE LCD MONITOR
Close the lens barrier and press the LCD monitor ON/OFF
button to turn on the LCD monitor.
When the monitor is turned on, the camera automatically
checks the card. If there is no card in the camera, the Card
error indicator blinks on the control panel. If the card is in
another format and is unreadable, the camera enters the
Card format mode. (p. 58)
The last picture taken is displayed on the LCD monitor. The
frame number and the battery check indicator are also
displayed, as well as the Date, Recording mode, and
Protect indicators if they are set. When there are no
pictures stored in the card, a blank blue screen is
displayed.
Recording mode, Battery Remaining, Date and Frame
number indicators will disappear after about three seconds.
If the batteries are low, the low-battery indicator appears
and blinks. Cancel the picture protection in order to make
the Protect indicator disappear. (p. 124)
You can adjust the brightness of the LCD monitor by
pressing 2 buttons at the same time: the Shutter release
button and the Next (+) button (to lighten) or Previous (–)
button (to darken).
Note:
When turned on, the LCD monitor flashes, and
pictures appear a few seconds later. This is not
a malfunction.
Publicidad
Tabla de contenido
