Tabla de contenido
Publicidad
Record/Play
switch
Commutateur
Enregistrement/
Affichage
Conmutador
grabación/
indicación en
pantalla
No picture in card
Pas d'image sur la
carte
No hay fotografía en
la tarjeta
Control Panel
Écran de commande
Panel de control
118
LCD Monitor
Écran ACL
Monitor LCD
2 0
9 8 .
9 .
2 1
2 3 : 3 4 : 5 3
N O
P I C T U R E
DISPLAYING PICTURES ON
E
THE LCD MONITOR
TURNING ON THE LCD MONITOR
Turn on the Play mode.
1
Set the Record/Play switch to Play, then turn on the
power.
2
When the Play mode is turned on, the last picture taken,
the date, and the frame number appear on the LCD
monitor. If there is no picture in the card, the Card error
mark/Error code blink on the control panel, and "NO
PICTURE" appears in red on the LCD monitor. (See page
70 for the Error code.)
The date disappears after three seconds unless PRINT is
set in DATE (p. 144).
See page 146 for adjusting the brightness of the LCD
monitor.
The modes can be switched between Record and Play
when the power is on.
Caution:
Do not touch the surface of the LCD monitor; this
can leave a blur on the monitor. Pushing hard
may break it.
Note:
When the camera is not operated for ten minutes,
the power save function activates and the power
turns off automatically.
Push the power button to turn on again.
Publicidad
Tabla de contenido
