Training in WATT mode
Select WATT, USE UP/DOWN to program
•
target watts (programmable between 10
up to 350 Watt), confirm with ENTER.
Program target value for time using
•
UP/DOWN/ENTER.
Press START.
•
The tension difficulty will be auto-adjusted
•
according to the Watt figure. If the figure is
under the target value, the tension
difficulty will be up-adjusted one level
every 30 seconds, up to the maximum
level 32. As soon as you achieved the set
value, tension difficulty will be down
adjusted one level immediately.
In case of overspec the level will be down
adjusted one level immediately, and keep
down-adjusting each 15 seconds until you
reach the preset value.
Stop/pause the exercise by pressing
•
STOP.
Press RESET to exit the program.
•
42