Cleaning, Maintenance, Storage, Transport And Ordering Of Spare Parts - EINHELL BG-PM 40 B&S Manual De Instrucciones Original

Anleitung_BG_PM_40_BS_SPK7__ 10.09.12 14:05 Seite 27
8. Cleaning, maintenance, storage,
transport and ordering of spare
parts
Important:
Never work on or touch any current-conducting parts
of the ignition system while the engine is running. Pull
the spark plug boot from the spark boot before doing
any maintenance or assembly work. Never carry out
any work on the equipment while the engine is
running. Work that is not described in these operating
instructions, should only be carried out by authorized
workshops.
8.1 Cleaning
The lawn mower should be cleaned thoroughly every
time after it has been used. This particularly applies to
its underside and the blade mount. For this purpose,
tilt the lawn mower onto its left side (opposite the oil-
filler neck).
Note: Before placing the lawn mower on its side, fully
drain the fuel tank using a petrol extraction pump. Do
not tilt the lawn mower by more then 90 degrees. It is
easiest to remove dirt and grass immediately after
mowing. Dried grass remnants and dirt may impair
the mowing operation. Check if the grass ejector
chute is free of grass remnants and remove any if
necessary. Never clean the mower using a water jet
or a high-pressure cleaner. Ensure that no water can
get into the interior of the equipment. Do not use
aggressive cleaning agents such as cold cleaners or
petroleum ether.
8.2 Servicing
Important: The enclosed engine manual from
Briggs & Stratton provides maintenance
information and maintenance interval
information on the engine.
Dispose of soiled maintenance material and
operating materials at the appropriate collection point.
8.2.1 Axles and wheel hubs
A thin coating of grease should be applied to the
axles and wheel hubs once per season. To do so,
remove the wheel caps with a screwdriver and loosen
the fastening screws on the wheels.
8.2.2 Blades
For safety reasons, have all blade sharpening,
balancing and mounting work carried out by an
authorized service center. To achieve optimal results,
we recommend to have the blades checked once a
year.
Changing the blades (Fig. 7)
When changing the cutting unit, be sure to use only
genuine replacement parts. The identification mark
on the blade must correspond with the number
specified in the spare parts list. Never install a blade
from a different manufacturer.
Damaged blades
If, in spite of all caution, the blade comes into contact
with an obstacle, switch off the engine immediately
and pull the spark plug boot. Tilt the mower to the
side and check the blade for damage. Damaged or
bent blades must be replaced. Never straighten a
bent blade. Never work with bent or heavily worn
blades as this will result in vibrations, causing further
damage to the mower.
Important: Risk of injury when working with a
damaged blade.
Resharpening the blade
The blade edges can be resharpened with a metal
file. To avoid imbalance, the blade resharpening work
should only be carried out by an authorized service
center.
8.2.3 Care and adjustment of the cable pulls
Oil the cable pulls at regular intervals and check that
they move easily.
8.2.4 Repair
After carrying out repair or maintenance work, ensure
that all safety parts are installed and in perfect
condition. Store potentially hazardous parts out of the
reach of other persons and children.
Important: In accordance with the German Product
Liability Act, we are not liable for any damages if they
result from improper repairs to the product or if parts
are replaced by items other than genuine parts or
parts approved by us. Furthermore, we are not liable
for any damages if they result from improper repairs
to the product. Arrange for your customer service or
an authorized workshop to do the work. The same
applies to accessory parts.
8.2.5 Operating times
Please observe the regulations concerning lawn
mower operating times, which may differ from town to
town.
GB
27