Tripp-Lite SmartOnline SU1000XLCD Manual Del Propietário página 15

Basic Connection and Start-Up
4 External Battery Connection
Check to ensure that the external batteries you are connecting
match the voltage listed on your UPS's battery connector. All UPS
models come with a robust internal battery system and feature
battery connectors for use with additional runtime. Additional
runtime will increase the required recharge time. See the battery
pack owner's manual for complete installation instructions. Make
sure cables are fully inserted into their connectors. Small sparks may
result during battery connection; this is normal. Do not connect or
disconnect battery packs when the UPS is running on battery power.
CAUTION: Do not open or mutilate batteries. Released material
is harmful to the skin and eyes. It may be toxic. The following
precautions should be observed when working on batteries:
Determine if the battery is inadvertently grounded. If inadvertently
grounded, remove the source from ground connection. Contact with any
part of a grounded battery can result in electrical shock. The likelihood
of such a shock can be reduced if grounds are removed during
installation and maintenance. (This is applicable to equipment and
remote battery supplies that do not have a grounded supply circuit.)
NOTE: External battery pack options require configuration using the
front panel LCD interface or via Tripp Lite's EXTERNAL BATTERY
CONFIGURATION software. See page 24 for more information if you
are connecting external batteries to one of these UPS models.
13-03-138 93-3168-EN.indd 15
4a
Take out the two screws to remove the external battery cover plate.
4b
15
3/28/2013 1:05:21 PM