Cold Start - Tripp-Lite SmartOnline SU1000XLCD Manual Del Propietário

Sistemas ups monofásicos en línea en torre con pantalla lcd integrada para monitoreo y control
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Features
2
ON button: This button offers five main functions depending on the state of the UPS when it is pressed: Power-on control,
alarm-cancel, self test, setup mode control and dimming control.
POWER ON
Turns the UPS ON into ONLINE or ECONOMY mode when pressed as
the UPS is in STANDBY mode
PRESS and HOLD the ON BUTTON until a BEEP is heard and RELEASE
The UPS display will flash ON for 30 seconds then automatically
switches to report the last viewed information screen.
HOW?
PRESS and HOLD the ON BUTTON until a BEEP is heard
(about 3 seconds), then RELEASE
WHEN? The UPS must be in standby mode and the LCD screen
reporting "OFF" for the POWER ON function to take effect.

COLD START

Turns the UPS ON into BATTERY MODE during a power failure for
temporary AC output
PRESS and HOLD the ON BUTTON until a BEEP is heard and RELEASE
The UPS will turn on after about 30 seconds and momentarily
report ON before switching to the last viewed informational screen
HOW? PRESS and HOLD the ON BUTTON until a BEEP is
heard (about 3 seconds), then RELEASE
WHEN? The UPS must be completely OFF with the LCD screen
UNLIT and have adequate battery charge for COLD
START to take effect.
13-03-138 93-3168-EN.indd 6
ALARM SILENCE
Temporarily sets the audible alarm to MUTE during a power failure.
Alarm will sound again for future power failures
TAP the ON BUTTON during BATTERY MODE
The Alarm will be temporarily silenced, but will re-sound for the
next alarm condition
HOW?
TAP the ON BUTTON (less than 1 second)
WHEN? The UPS must be running in BATTERY MODE with the
Alarm sounding for the ALARM SILENCE to take effect.
SELF TEST
Performs a momentary test of the UPS battery system and reports
PASS / FAIL results.
PRESS and HOLD the ON BUTTON until a BEEP is heard and RELEASE
The LCD screen will flash TEST and BATTERY while reporting
battery voltage for 10-15 seconds, then the screen will report
the testing results using the three digit display:
PAS = PASS / BAD = FAIL
See the Troubleshooting section for more information
HOW?
PRESS and HOLD the ON BUTTON until a BEEP is heard
(about 3 seconds), then RELEASE
WHEN? The UPS must be running in ONLINE (shown above),
ECONOMY, FREQUENCY REGULATION or FREQUENCY
CONVERSION MODE for the SELF TEST to take effect.
NOTE: After first plugging in the unit, wait 24 hours before running the first self-test.
The self-test will not run if battery voltage is too low.
6
3/28/2013 1:04:50 PM

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido