Ups Setup Overview; Using The Lcd Interface - Tripp-Lite SmartOnline SU1000XLCD Manual Del Propietário

Operation

UPS SETUP OVERVIEW

Your UPS supports a variety of advanced configuration options that can be set up via the front panel LCD screen interface. Some external
battery configurations will require the use of External Battery Configuration Software and a RS232 connection to the UPS. PowerAlert
UPS monitoring software can also be used to access many advanced configuration options through the use of a direct USB, RS232 or
SNMPWEBCARD connection (skip past the LCD set-up instructions for advanced configuration options using PowerAlert).

1. USING THE LCD INTERFACE

This UPS supports a variety of user setup options and custom configurations that can be accessed via the front panel LCD screen.
Configuration and information items include.
1. Output Voltage
2. Output Frequency
3. Frequency Converter/Regulation
To access the UPS SETUP MENU, press the SETUP BUTTON for approximately 3 seconds and release.
To gain access to all configuration items, Turn off connected equipment and set the UPS to STANDBY MODE (the UPS is in STANDBY mode
when the 3 character LCD display reads "OFF").
Many LCD configuration items cannot be changed in ON LINE, ON BATTERY, ECONOMY or FREQUENCY REGULATION/CONVERTER modes.
If a non-supported configuration item is attempted during these modes, the LCD will report "no" to confirm the selection is not available in
the current operating mode.
Once your configuration settings are complete, EXIT the SETUP MENU by pressing and holding the SETUP BUTTON for approximately 3 seconds.
UPS Set-up Using the LCD Screen
To access the UPS SETUP MENU, press the front panel SETUP BUTTON for approximately 3 seconds and release.
1
The OUTPUT VOLTAGE selection screen will appear. The last selected UPS OUTPUT voltage setting will appear. If this is your first
time running the SETUP MENU, the factory default setting of 120V will be shown.
OUTPUT VOLTAGE refers to the nominal output voltage of the UPS. This value is most
commonly set to match the prevailing country or region-specific nominal voltage. In general,
use 120V for USA and Canada, 127V for Mexico and 100V for Japan. Additional values of
110 & 115V are also available. Note: Certain voltage settings will cause automatic de-rating.
See specifications on unit label for de-rating info.
ACCEPT AND ADVANCE
To ACCEPT the current value
& ADVANCE to the next
configuration screen , press
the ON/SELECT button (less
than 1 second).
* The currently selected value will show as solid. Alternate values will flash and then remain solid once selected.
13-03-138 93-3168-EN.indd 21
4. Bypass range
5. Economy Mode
6. Audible Alarm
VIEW ALTERNATE SETTINGS
To VIEW ALTERNATE SETTINGS,
press the SETUP BUTTON
repeatedly (under 1 second
each).
AVAILABLE VALUES*
120V (factory), 127V,
100V, 110V, 115V
21
7. Overload Alarm
8. External Batt.
9. IP address
LEAVE UPS SETUP MODE
To leave UPS setup mode,
PRESS and HOLD the SETUP
BUTTON (about 3 seconds).
NOTE - the UPS must be in STANDBY MODE
to change the output voltage setting
3/28/2013 1:05:35 PM