Removing The Fastener Guide; Inserting The Fastener Guide; Loading The Fastening Tool With Nails - Hilti BX 3-ME Manual De Instrucciones Original

5.2 Inserting the battery
Note
In order to achieve maximum battery lifetime, replace the discharged battery with a fully charged
battery as soon as you notice a clear drop in battery performance.
1. Check that the contacts on the battery and on the tool are free from foreign objects.
2. Fit the battery and make sure that it is heard to engage.
◁ Once the battery has been fitted, the charge status LEDs light for a short time.
CAUTION
A falling battery presents a hazard. If the battery is not secured correctly it may drop out and fall
while the work is in progress.
▶ Always check that the battery is securely seated.
3. Check that the battery is securely seated in the fastening tool.

5.3 Removing the fastener guide

1. Switch the fastening tool off. → page 10
2. Remove the battery. → page 10
3. Pull the nail pusher down until it engages.
4. Unload the magazine. → page 10
5. Slide the fastener guide locking catch as far as it will go in the direction of the arrow.
◁ The fastener guide will be released.
6. Remove the fastener guide.

5.4 Inserting the fastener guide

1. Switch the fastening tool off. → page 10
2. Remove the battery. → page 10
3. Pull the nail pusher down until it engages.
4. Unload the magazine. → page 10
5. Slide the fastener guide locking catch as far as it will go in the direction of the arrow and hold it in this
position.
6. Slide the fastener guide into the nosepiece until it is heard to engage.
7. Release the fastener guide locking catch.
◁ The fastener guide jumps to the middle position.
8. Grip and pull the fastener guide to check that it is securely seated.
5.5 Working safely with the belt and scaffold hook
▶ Before beginning work, make sure that the scaffold hook is securely attached to the tool.
▶ Use the scaffold hook only when necessary. Lay the tool down in a safe place when it is not in use for a
long period.

5.6 Loading the fastening tool with nails

5.6.1 Loading for magazine operation
CAUTION
Risk of crushing! The nail pusher, if it jumps back under spring pressure, may cause injury and
damage to the fastening tool.
▶ When pulling the nail pusher down, take care to ensure that it engages securely. Do not allow the
nail pusher to jump back under spring pressure.
1. Pull the nail pusher down until it engages.
2. Slide the nail strips into the magazine (a maximum of 2 strips of 10 nails).
3. Hold the nail pusher securely and press the nail pusher release button.
4. Guide the nail pusher back to its original position.
8 English
Printed: 24.08.2016 | Doc-Nr: PUB / 5269973 / 000 / 02
2
4
3