Inserting The Battery; Inserting The Fastener Guide - Hilti NURON BX 3-22 Manual De Instrucciones

3. Use an approved charger to charge the battery. → page 24
5.2

Inserting the battery

WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.
5.3 Removing the battery
1. Press the battery release button.
2. Remove the battery from the product.
5.4 Removing the fastener guide
1. Pull the nail pusher down until it engages.
2. Unload the magazine. → page 32
3. Slide the fastener guide locking catch as far as it will go in the direction of the arrow.
▶ The fastener guide will be released.
4. Remove the fastener guide.
5.5

Inserting the fastener guide

1. Pull the nail pusher down until it engages.
2. Unload the magazine. → page 32
3. Slide the fastener guide locking catch as far as it will go in the direction of the arrow and hold it in this
position.
4. Slide the fastener guide into the nosepiece until it is heard to engage.
5. Release the fastener guide locking catch.
▶ The fastener guide jumps to the middle position.
6. Grip and pull the fastener guide to check that it is securely seated.
5.6 Working safely with the belt and scaffold hook
▶ Before beginning work, make sure that the belt hook / scaffold hook is securely attached to the product.
▶ Use the belt hook / scaffold hook only when necessary. Put the product safely aside if it is to remain
unused for a lengthy period of time.
5.7 Fall arrest 3
WARNING
Risk of injury by falling tool and/or accessory!
▶ Use only the Hilti tool tether recommended for your product.
▶ Prior to each use, always check the attachment point of the tool tether for possible damage.
▶ Do not secure a tool tether to the belt hook. Do not use a belt hook to lift the product.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only the Hilti tool tether #2261970.
▶ Use one carabiner to secure the tool tether to the product as shown in the illustration. Check that the
carabiner holds securely.
*2268212*
2268212
2
English 29