Custom Drawer Front Attachment (Optional); Custom Drawer Front Dimensions; Custom Panels Must Meet The Following Requirements; Custom Drawer Front Preparation - Thermador MASTERPIECE WDC30J Manual De Instalación

Custom Drawer Front
Dimensions
WDC30J
Specifications and Dimensions
WDC30J
Product Width 29½" (749 mm)
Product Height 10½" (267 mm)
Product Depth 22" (559 mm)
Cutout Width 28½" (724 mm)
Cutout Height 10" (254 mm)
Cutout Depth 23" (584 mm)
Minimum 29 ¾" (756 mm)
Front Panel Width 11¼" (286 mm)
Front Panel Height
Front Panel Depth
Clearance for door
opening plus custom panel & handle depth
Electrical Supply 120 V AC, 60Hz
Circuit Breaker
Wattage
Power Cord Incl. 120V-3-Wire
Cord Length 72" (1,829 mm)
Shipping Weight 65 lbs (30 kg)
WDC36J
WDC36J
35½" (902 mm)
10½" (267 mm)
22" (559 mm)
34½" (876 mm)
10" (254 mm)
23" (584 mm)
35 " (907 mm)
11
/
16
11¼" (286 mm)
¾" (19 mm) ¾" (19 mm)
18¾" (476 mm)
120 V AC, 60Hz
15 Amp 15 Amp
930 1080
120V-3-Wire
72" (1,829 mm)
75 lbs (34 kg)
Custom panels must meet the following
requirements:
• Have a handle.
• Have a minimum thickness of 3/4" (19 mm).
• Have all edges finished.
• If using wood, the back must be sealed to prevent
moisture damage.
• Be capable of withstanding temperatures above 158 °F
(70 °C).

Custom Drawer Front Preparation

1. Mark pilot holes on the back side of the panel
according to the dimensions indicated in Figure 5 on
page 8.
2. Drill pilot holes with a 3/32" (2.5 mm) drill bit. Be
careful not to drill all the way through the panel.
Pilot holes should only be 7/16" (11 mm) deep, see
Figure 6 on page 8.
3. Attach your own handle.
English 7