Installation Procedure Wd30W; Preparing The Custom Panel For Installation - Thermador Masterpiece and Professional Series Guía Para La Instalación

Installation Procedure WD30W

CAUTION
9
Never operate the warming drawer without a front
panel attached. You can attach a Thermador® front
panel or a custom front panel.
CAUTION
9
DO NOT lift the warming drawer by the door's
handle as this may damage the slides and cause
the door to fit incorrectly.
WARNING
9
DO NOT REPAIR OR REPLACE PARTS
Do not repair or replace any part of the appliance
unless specifically recommended in the manual.
Improper installation, service or maintenance can
cause injury or property damage. Refer to this
manual for guidance. All other servicing should be
done by an authorized servicer.
The electrical outlet can be installed in the back wall
directly behind the warming drawer. A recessed power
receptacle must not exceed 5
distance from either side of the warming drawer cutout.
Installation clearances permit for the excess power cord
to be coiled behind the appliance.
DO NOT install this warming drawer in wet locations or
outdoors.
CAUTION
9
Before installing, turn power OFF at the service
panel. Lock service panel to prevent power from
being turned ON accidentally.
/ ft. (1.7m) maximum
1
2
Preparing the Custom Panel for
Installation
Custom panels must meet the following requirements:
Custom panel is provided by the customer.
▯
Have a handle provided by the customer.
▯
Have a minimum thickness of 3/4" (19 mm).
▯
Have all edges finished.
▯
If using wood, the back must be sealed to prevent
▯
moisture damage.
Be capable of withstanding temperatures above
▯
158°F (70°C).
Custom Panel Front Preparation
Mark pilot holes based on the dimensions in the
1.
template diagram below.
When drilling pilot and clearance holes, be careful not
2.
to drill all the way through the panel. Pilot holes should
only be 10mm (7/16") deep.
Dimensions are in millimeters (inches).
3.
It is recommended to attach the desired handle/knob
4.
using metal fasteners.
17