Troubleshooting; Helpful Reminders - Hoover MAX Extract DUAL V Manual Del Propietário

If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the
checklist below.
Any other servicing should be done by an authorized service representative.
To reduce risk of personal injury - unplug cleaner before servicing.
probleM
Cleaner won't run. 1. Not firmly plugged in.
Low suction.
Clean water won't
dispense.
Detergent won't
dispense
brushes/brush
indicator won't
rotate during floor
cleaning.

helpful reMinders

CAUTION
!
Unplug the cleaner before doing any of the
following.
• Use HOOVER
®
brand detergents; others may
foam too much or cause leaking.
• Use extra dry strokes to aid in faster drying of the
carpet.
• 6.1 Fill tank (A) with hot (under 140˚F /60˚C) tap
water ONLY. Do not put any detergent in water
tank. Fill detergent container (B) with HOOVER
detergent.
• 6.2 Secure Dirty Water Tank lid before cleaning.
• Empty Dirty Water Tank when full or when
automatic shut-off engages.

6. troubleshootinG

WARNING
!
possible Cause
2. No voltage in wall plug.
3. Blown fuse or tripped
breaker.
1. Dirty Water Tank full/
automatic shut off engaged.
2. Blockage In tool on end of
hose.
3. Dirty Water Tank lid not on
correctly.
4. Clean Water Tank empty, but
detergent remains.
1. Clean Water Tank not firmly
in place.
2. Clean Water Tank or
detergent container empty.
3. Dirty Water Tank lid not on
correctly.
1. Valve cap clogged.
1. Dirty filter screen on bottom
of unit.
!
!
POSSIBLE SOLUTION
1. Plug unit in firmly.
2. Check fuse or breaker in home.
3. Replace fuse or reset breaker in home.
1.Remove and empty Dirty Water Tank. Clean
filter screen.
2. Remove tool and clear blockage.
3. Make sure lid is on securely.
4. Fill Clean Water Tank
1. Make sure tank is securely locked in
position.
2. Refill container according to instructions for
surface being cleaned.
3 .Make sure lid is firmly in place.
1. Remove and clean valve cap
(see instructions below).
1. Clean screen.
6.1
b
®
19 Actual model may vary from images shown.
6.2
A