SEA MARK TANK E 270 Manual De Instalación página 7

Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
INSTALLATION OF THE OSCILLATING REAR BRACKET
(1)
Fig. 9
INSTALLATION OF REAR
BRACKET
According to the type of opening that you have chosen
(inside or outside) and to the chosen leaf rotation (see
page 5-6), the rear bracket must first be cut respecting the
quote "a" on page 5-6 and then welded as in fig. 10.
The support must be positioned so that the operator is
perfectly levelled (Fig. 10, Fig. 12)
Adjustable rear bracket (with screws)
(Accessory on demand)
55 mm
Fig. 11
67410019
®
PRELIMINARY
- Open carefully the package, making sure
not to loose parts which are listed in fig. 3
- Attach the rear oscillating bracket as
shown in fig. 9
Attention: Do not use a hammer for the
insertion of the short brass pin; its fitting
into the bracket and clevis attachment must be
done by the simple pressure of the hands.
Fig. 8
Attention: Do not incline the hydraulic
operator further than the allowed angle of the
oscillating bracket (1), risks the possible
braking of it.
Fig. 10
REV 00 - 07/2013
MARK TANK E
English English
7