Tabla de contenido
Publicidad
Sistemi Elettronici
di Apertura Porte e Cancelli
International registered trademark n. 804888
BREATHER SCREW
TORQUE ADJUSTMENT (by pass valves)
Fig. 18
-
Grey
Adjust the opening and closing forces of the gate so that the diagram of the force is respected (present in the regulation
EN 12453); Anyway the max. thrust force should never be superior of 15 KgF.
67410019
®
Fig. 16
Unscrew and remove
the screw under the
operator at the end
Acting on the by-pas
valves, it is possible to
a d j u s t t h e o p e r a t o r
pressure in the opening
and closing process.
Down
By-Pass Valves
-
+
ATTENTION
It is obligatory to remove the breather
screw at the end of the installation.
of installation
Up
+
Yellow
REV 00 - 07/2013
MARK TANK E
English
English
Fig. 17
Grey
Yellow
Fig. 19
Up
Fig. 20
9
Publicidad
Tabla de contenido
