Noise/Vibration Information; For Your Safety; Battery Charging (See Figure A) - Bosch Xeo Manual Original

OBJ_BUCH-377-009.book Page 20 Monday, December 11, 2017 11:03 AM
20 | English

Noise/Vibration Information

Sound emission values determined according to EN 60745-1.
Typically the A-weighted sound pressure level of the product is less than 70 dB(A).
Uncertainty K =3 dB.
The noise level when working can exceed 80 dB(A).
Wear hearing protection!
Vibration total values a (triax vector sum) and uncertainty K determined according
h
to EN 60745-1: a <2,5 m/s
h
The vibration level given in this information sheet has been measured in accordance
with a standardised test given in EN 60745 and may be used to compare one tool
with another. It may be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main applications of the tool.
However if the tool is used for different applications, with different accessories or in-
sertion tools or is poorly maintained, the vibration emission may differ. This may sig-
nificantly increase the exposure level over the total working period.
An estimation of the level of exposure to vibration should also take into account the
times when the tool is switched off or when it is running but not actually doing the job.
This may significantly reduce the exposure level over the total working period.
Identify additional safety measures to protect the operator from the effects of vibra-
tion such as: maintain the tool and the accessories, keep the hands warm, organisa-
tion of work patterns.
Assembly

For Your Safety

 Warning! Prior to any maintenance and cleaning, switch the machine off and
secure the lock-off button 2.

Battery Charging (see figure A)

 Do not use other battery chargers. The supplied battery charger is designed for
the Lithium-Ion battery in your machine.
 Observe the mains voltage! The voltage of the power supply must correspond
with the data given on the nameplate of the battery charger. Battery chargers
marked with 230 V can also be operated with 220 V.
3–5 h
The lithium-ion battery can be charged at any time without reducing its service life.
Interrupting the charging procedure does not damage the battery.
The lithium-ion battery is protected against deep discharging by the "Electronic Cell
Protection (ECP)". When the battery is empty, the machine is switched off by means
of a protective circuit: The inserted tool no longer rotates.
 Do not continue to press the On/Off switch after the machine has been auto-
matically switched off. The battery can be damaged.
1 609 92A 48X | (11.12.17)
2 2
, K=1,5 m/s .
The battery is supplied partially charged.
To ensure full battery capacity, completely charge the
battery (at least 3–5 hours) before using for the first
time.
The power tool cannot be used during the charge proce-
dure; it is not defective when inoperative during the
charging procedure.
Bosch Power Tools