Deleting A Remote Control; Accessories; Ca41 Module (For T11); Kb Or 128 Kbits Memory Expansion Module (For T11) - Aprimatic T11 Instrucciones Para La Instalación

• To quit the saving procedure, simply press the delete button.
• In any case, the system remains in self-teaching mode (continuous buzzer)
for a maximum of about 25 seconds before the receiver automatically returns to
normal mode (buzzer OFF).
• During the self-teaching procedure, the device outputs are disabled.

5.5 DELETING A REMOTE CONTROL

1. With the device powered up, hold down the delete button: the DL6 LED and the
BZ1 buzzer come on (continuous buzzer).
2. Press any button on the remote control you want to delete.
3. The DL6 LED and the BZ1 buzzer will go off to indicate that deletion of the
remote control is complete.
Power supply
Button
Remote control
activation
Buzzer
• To delete more than one remote control, repeat stage 2 above, holding down
the button.
• This procedure is useful for deleting remote controls which have been saved
by mistake. However, you can subsequently save the remote control deleted in the
receiver again, following the procedure described above.

6. ACCESSORIES

NOTE - Please refer to tht specifi c accessory instruction manual.
(FOR T11)
6.1 CA41 MODULE
By fi tting this module to the device, the user will have an additional receiving channel: in
this way, with the SAME DEVICE AND THE Aprimatic two-key STANDARD REMOTE
CONTROL, he will be able to control two different appliances.
6.2 16 KB OR 128 KBITS MEMORY EXPANSION MODULE
By fi tting this module to the device, the latter will be enabled to controlup to 1500
operations.
(FOR T11)
6.3 PROGRAMMING TOOLS
The Aprimatic devices and remote controls can also be programmed using:
• APRITOOL programmer for the access control management
• APRICOT-MANAGER software for managing access controls
• Connecting unit for programming APRIBASE 1 transmitters.
6.4 SAFETY CARD (for electromechanical motors APRIMATIC-230 VAC)
Accessory card for activating the anti-crush function for both motors. Functioning is
factory-set and shall not be adjusted.
When the anti-crush function is activated, the led corresponding to the involved
motor lights up on the card.

6.5 CODED KEYPAD

It is possible to install a coded keypad by connecting the CT3 decoding card to
the K3 connector.

6.6 BADGE READER

It is possible to fi t a badge reader by connecting the LB4 decoding card to the
K3 connector.
(FOR T11)