Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5. Continue until the screen is set up as required.
6. Exit screen setup mode by pressing and holding the
Note: If an actual camera is placed into the segments allocated for sequence within either the P in P or Multiscreen displays
these sequences will not be available from the front panel keyboard. To return these sequence functions repeat the screen edit
procedure above without selecting cameras into these segments.
Freezing the image
An image can be frozen in live and playback modes by double pressing (in rapid succession) the camera key in any screen mode.
The word 'HOLD' is displayed in the top left hand corner of each held image. Pressing the camera key again will unfreeze the
image, and remove the 'HOLD' text.
An image can be frozen in live and playback modes by simply pressing the
word 'HOLD' is displayed in the top left hand corner of each image. Pressing the
image, and remove the 'HOLD' text.
Electronically zooming into an image
The zoom function can be enabled by pressing the selected camera key again whilst in full screen mode. The cursor keys are used
to move around the zoomed image. Pressing the camera key again will exit zoom mode.
Sequencing cameras
A sequence of cameras can be displayed on the main, spot, or both video monitors.
With a full screen image displayed on the main monitor, pressing the Full key will start a full screen sequence. Pressing any
camera key will immediately stop the sequence.
To start the sequence on the main monitor, press the
Pressing the
key within P in P, Quad and Multiscreen modes will start their allotted segment to sequence. All
SEQUENCE
multiscreen sequences comprise all cameras excluding those already displayed onscreen. Releasing the
the multiscreen sequence.
Version 1.0
/
key for approximately 3 seconds.
MENU
MODE
key in any screen mode. The
HOLD
HOLD
key.
SEQUENCE
Operating in Live and Play Mode
key again will unfreeze the
key will stop
SEQUENCE
33
Publicidad
Capítulos
Tabla de contenido
