Craftsman 320.17255 Manual De Operaciones página 25

/%, WARNING:
ALWAYS clamp and support workpiece securely. ALWAYS
maintain proper control of saw. Failure to clamp and support workpiece and
loss of control of saw could result in serious injury.
BEVEL ASSIST HANDLE INSTALLATION AND USE (Fig. 22)
The bevel assist handle will provide
maximum control when making bevel cuts.
1. The bevel assist handle can be
attached to either side of the
saw. Position the handle on the
side of the saw that faces up and
away from the workpiece.
(see Fig. 21b and 22)
USING EDGE GUIDE (Fig. 23)
Fig. 22
jJ"
,J'
WARNING"
ALWAYS unplug saw from the power source BEFORE making
any adjustments or attaching accessories.
1. Insert the bar of the edge guide
through the slots in the base of
the sabre saw (see Fig. 23).
The edge guide can be inserted
from either side of the base, with
the guide edge facing down.
2. Screw the edge guide locking knob
into the threaded hole in the base
to tighten the edge guide bar in place.
3. Measure the distance from the edge
of the workpiece to the line of cut.
Slide the edge guide to this desired
distance and tighten the locking
knob to secure edge guide in place.
Fig. 23
25