Craftsman 320.17255 Manual De Operaciones página 7

SAFETY SYMBOLS FOR YOUR TOOL
The label on your tool may include the following symbols.
V ....................................................................... Volts
A ...................................................................... Amps
Hz .................................................................... Hertz
W ..................................................................... Watts
min .................................................................. Minutes
,-,,_,.................................................................... Alternating current
................................................................... Direct current
no .................................................................... No-load speed
[] ..................................................................... Class II construction, Double Insulated
.../min .............................................................. Revolutions or Strokes per minute
Z_- .................................................................... Indicates danger, warning or caution.
It means attention! Your safety is involved.
SERVICE SAFETY
1. If any part of this saw is missing or should break, bend, or fail in any way;
or should any electrical component fail to perform properly: SHUT OFF
the power switch and remove the saw plug from the power source and have
the missing, damaged or failed parts replaced BEFORE resuming operation.
2. Tool service must be performed only at a Sears Parts and Repair Center.
Service or maintenance performed by unqualified personnel could result in
a risk of injury.
3. When servicing a tool, use only identical replacement parts. Follow
instructions in the maintenance section of this manual. Use of unauthorized
parts or failure to follow maintenance instructions may create a risk of electric
shock or injury.
SAFETY RULES FOR SABRE SAWS
Keep hands away from cutting area and blade. Keep your second
hand on the auxiliary handle or motor housing. If both hands are holding the saw, the
blade cannot cut them.
z_ CAUTION:
Blades coast after saw is switched off
i. KEEP your body positioned to either side of the saw blade and not in direct line
with the saw blade.
_>.DO NOT reach under the workpiece. The blade extends under the workpiece when
saw is cutting.
3. DO NOT touch the blade or the workpiece immediately after operation; they may
be extremely hot and could burn your skin.
L DO NOT cut an oversized workpiece.
_. CHECK for the proper clearance under the workpiece before cutting so that the
blade will not strike the workbench or material under the workpiece.
;. MAKE SURE the blade is not contacting the workpiece before the switch
is turned on.
7