Craftsman 320.17255 Manual De Operaciones página 26

WAR N IN G:
Preventive maintenance performed by unauthorized personnel
may result in misplacing of internal wires and components, which could cause a
serious hazard.
SERVICE
1. When servicing a tool, use only identical replacement parts. Use of unauthorized parts or
failure to follow maintenance instructions may create a risk of electrical shock or serious
personal injury.
2. All service that requires opening the sabre saw MUST ONLY be performed by a Sears
Service Center. All motor parts represent an important part of the double insulation
system and MUST ONLY be serviced by a Sears Service Center. Service performed by
unqualified personnel could result in a risk of injury.
3. Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to
damage from various types of commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, carbon dust, etc.
GENERAL
WARNING:
ALWAYS disconnect the tool from the power source BEFORE I
cleaning or performing any maintenance.
I
WARNING:
DO NOT at any time let brake fluids, gasoline, petroleum-based
products, penetrating oils, etc. come in contact With plastic parts. Chemicals can
damage, weaken or destroy plastic, which may result in serious personal injury.
It has been found that electric tools are subject to accelerated wear and possible premature
failure when they are used to work on fiber glass boats and sports cars, wallboard, spackling
compounds or plaster. The chips and grindings from these materials are highly abrasive to
electrical tool parts, such as bearings, brushes, commutators, etc. Consequently, it is not
recommended that this tool be used for extended work on any fiberglass material, wallboard,
spackling compound or plaster. During any use on these materials, it is extremely
important that the tool is cleaned frequently by blowing with an air jet.
WARNING"
Always wear safety goggles or safety glasses with side shields
during power tool operations, or when blowing dust. If operation is dusty, also
wear a dust mask.
LUBRICATION
All of the bearings in this tool are lubricated with a sufficient amount of high-grade lubricant
for the life of the tool under normal operating conditions. Therefore, no further lubrication is
required.
26