Kenmore 125.10701610 Manual De Uso página 15

WARNING
Turn off and unplug vacuum cleaner
before washing the dust bin.
NOTE: It is not necessary to wash the dust
filter after each vacuum use. Only wash filter
when it appears to be very dirty or there is
a noticeable reduction in vacuum suction
performance.
1. Remove loose dust (See EMPTYING DUST
BIN, page 13).
2. Push the dust filter cover release latch to
pull out dust filter cover.
Locating
Mark
3. Wash all parts of the dust bin, including
the filter. DO NOT wash in the
dishwasher.
WASHING DUST BIN
Dust Filter
Cover Release
Latch
Dust Filter
Cover
4. Allow filter to dry 24 hours before
putting back into vacuum cleaner. DO
NOT install damp.
CAUTION
• Do no attempt to dry the dust filter
with a hair dryer or by placing it in
a clothes dryer.
5. Install the dust filter cover along the inside
of locating strip, and make sure you hear
a "click." DO NOT operate without filter
installed.
Inside of
locating
strip
6. Close filter door and reattach dust bin to
vacuum cleaner as shown.
NOTES:
• If filter is torn or perforated, replace it
before using vacuum.
• When the cleaning of the filter no longer
restores vacuum cleaner suctionto full
power, replace the filter.
- 15 -
Dust Filter
Cover